POLYOXAL HB | 400GM BASE & 400GM CATALYST | Dental Silicone Impression Material | Heavy Body Putty

INTRODUCTION: Polyoxal is available in 3consistencies and is easy to apply for precision dental impression taking. POLYOXAL HB PUTTY: Primary impression material for doubleimpression technique. Meets the requirements of DIN 13913 A1, ISO 4823 Type I, Cat. A POLYOXAL MB: MEDIUM VISCOSITY Syringe material, double mixing technique, impression taking of edentulous jaws, and denture re-lining impression taking. Meets the requirements of DIN 13913 C1, ISO 4823 Type3 Cat. A. POLYOXAL LB: LOW VISCOSITY Double impression technique correcting material. Syringe material meets requirements of DIN 13913 C1, ISO 4823 Type 3 Cats A. MIXING RATIO: Equal parts 1:1 (volume or weight) of base and catalyst paste are recommended which although different in colour, have the same consistency, so that an easily controlled homogeneous mix is obtained. MIXING TECHNIQUE: Polyoxal MB & LB: Dispense the same quantities of base and catalyst, onto a mixing pad, mix together with a plastic or stainless steel spatula within the mixing time of 1 minute to obtain a homogeneous colour ready for tray loading. Polyoxal HB: Using the separate measuring spoons, dose 1 level scoopful of each and knead for 1 minute to obtain a homogeneous colour. APPLICATION: Polyoxal HB: Putty- Dosage 1:1 0 min.-------------- 1 min.------- -----2 min. 30sec.------------- 4 min.-------- ---- 6 min. 30sec.              Mixing                 Loading                      Holding Time           Remove               Time                    Time                            in Mouth           from Mouth Polyoxal MB: Med. Viscosity- Dosage 1:1 0min.-------------- 1 min.------- -----2 min. 45sec.------------- 4 min.-------- ---- 6 min. 45sec.              Mixing                  Loading                             Holding Time            Remove               Time                      Time                                  in Mouth               from Mouth Polyoxal LB: Low Viscosity Dosage 1:1 0 min.-------------- 1 min.------- -----2 min. 45sec.------------- 4 min.-------- ---- 6 min. 45sec. Mixing              Loading                         Holding Time            Remove Time               Time                               in Mouth                from Mouth Use typically at 23°C. Relative humidity: 50%.Higher temperature shortens these times and lower temperatures lengthen these times. IMPORTANT: Latex based rubber gloves should not be used when mixing Polyoxal HB. Tubs and syringes should be closed immediately after use, with the correct closures. Do not interchange the caps of the tubs. The impression can be poured 1 hour after removal. STORAGE: Maximum temperature 25°C, relative humidity 50 5%. Do not use after expiry date. CAUTION: Avoid contact with the eyes. In case of contact occurs wash immediately with plenty of water or use eye-washers. Seek medical advice if necessary. Material may stain clothing.